new JUMBO 3D Printed How to Train Your Dragon Toothless Multicolor

Description: Hello! Thanks for stopping by! You are looking at a new special listing for my Toothless print. Some people have asked for them to be bigger, and this is 40% bigger that the normal dragons. They barely fit on my 3D printer and I can only print one at a time instead of the usual three at a time! They are designed by the talented Saber3D. I am an authorized reseller of their designs. These dragons have fully articulating tails and legs and can stand on their own as pictured. The wings of these dragons are printed separately, then snap on with a ball-joint mechanism. So, while they could technically be removed, I think it would be a good idea to leave them in place. These dragons are roughly a full foot long (12 inches) and the wingspan from tip to tip is 14 inches. Compare this to the normal dragon size of 8.25 inches in length with a wingspan of about 10 inches. While this might not seem like a big size increase, in person, the dragons are massive compared to the original ones. I take my 3D prints seriously, so the filaments I use are properly dried and my printers are properly calibrated for each print to ensure a beautiful finish every time. PLA is great for general use, but please do keep in mind that it can start to deform if left in direct sunlight for a long period of time or left in the car, or subjected to any other high heat source. My reputation speaks for itself, please buy with confidence, and please reach out if you have any questions. Thank you.The smaller dragon shown in the last photo is for size demonstration purposes only and won't be included in the order.

Price: 27.99 USD

Location: Saint Cloud, Florida

End Time: 2024-11-26T15:43:23.000Z

Shipping Cost: N/A USD