MOTORIZED BICYCLE 12 Volt Generator 2 CYCLE Engine Lights -Battery

Description: wonderful creations motorized bicycle lights MOTORIZED BICYCLE 12 Volt Generator 2 CYCLE Engine Lights -Battery Here's a 12 Volt Dynamo Generator (12 Volt Mini-Gen) designed for motorized bicycle 2-cycle engines. This generator produces electricity to run bike lights or other systems up to 10 watts (recommended) Install this 12 Volt Mini-Gen into your 2 cycle engine as seen in photo. This will product AC voltage while engine is running. Voltage will increase with engine speeds, accumulating to 12 volts @ just above idle speeds and more at high speeds. The Mini-Gen can be used to run your lights directly or used to charge a battery which is connected to your lights or other electrical accessories. To run headlights directly, the headlight should be: 1. Rated about no more than 10 watts (recommended) 2. Compatible with AC voltage. Any dynamo type bicycle 12 volt headlight should work just fine since the bicycle dynamo is also an AC volt generator. Scooter type LED headlights would also work, but most are not AC voltage compatible, so might not get full brightness with AC generator. They work better with DC volts (battery). Compatible 12 Volt LED Headlights are available in our eBay store. To use this Mini-Gen for battery charging, do NOT connect it directly to battery. A rectifier must be used, preferably with a voltage regulator so battery is not overcharged. A rectifier will convert AC volts to DC volts for charging your battery. A battery charging device called the Mini-Charger is available in our eBay store, and is available for both 6 volts and 12 volts battery charging. ACCESSORIES: Here are a few accessories that might interest you; This light switch can be conveniently used with your Mini- Generator for direct lighting. The ground wire will send Mini-Gen power to neutral when generator power is turned off. The switch can also be used with a Mini-Gen battery/charger system, but don't use the black ground wire. Get these set of 3 wires for your bike lighting or electrical project. Each of the three wires are 72" (inches) long. You'll want to have wire connectors available for your project. Here are four types of wire connectors; 10 x female bullet, 10 x male bullets, 10 x butt connectors and 5 x 1/4" ring terminals. These are all 22-18 gauge. Maybe you would like to get all of these items and save on shipping. This deal will get you all 3 and should handle all your bike wiring needs.

Price: 29.01 USD

Location: Hollywood, Florida

End Time: 2024-02-26T01:19:41.000Z

Shipping Cost: 4.95 USD